On-Line Helium Leak Detection Eddy Current Testing NDT Inspection NDT level-II certification & Training  
 

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

 
 

EDDY CURRENT TESTING

Nexus provides Eddy Current Testing services, to characterize and detect pitting, microbiological induced corrosion damage, fatigue crack, inter-granular stress corrosion cracks, support wear, erosion etc, sub surface defects (inclusions, voids etc.). It can easily identify material discontinuities in new tubes also without impairing the intended use of the non- magnetic materials (tubes).Eddy Current Testing services is an electro- magnetic NDT technique widely used in Power Plants (Nuclear, Thermal, Gas Turbine), Petrochemical, Refineries and other Industries where tubular Heat Exchangers, Coolers, Condensers are provided.

Eddy current Test shall be done as per the ASME section-V, article 08. Multi Frequency, multi channel eddy current equipment is used for in-service inspection of condenser/ heat exchanger tubes.

 
EDDY CURRENT TESTING 
 

Nexus provides Remote field testing (RFET) to inspect ferromagnetic tubing such as carbon steel or ferrite stainless steel. This technology offers good sensitivity when detecting and measuring volumetric defects resulting from erosion, corrosion, wear, and baffle cuts.

Olympus remote field probes and the Multi Scan™ MS 5800 are used to successfully inspect heat exchangers, feed water heaters, and boiler tubes, around the world.


MS 5800R(RFET)
 
  • RFET with up to four different frequencies and real-time mixes. This feature allows more flexibility for mixing and defect validation. The detection and sizing of flaws at the support plate becomes easier with multi-frequency inspections and dual-driver operations.
  • RFET with frequencies ranging from 20 Hz to 250 kHz. The high frequency available with the Multi Scan MS 5800R™ extends the RFET inspection to thin materials with low permeability, such as the stainless steel 400 series and other ferromagnetic alloys

Assuring you of our prompt services at all times
We solicit your valuable enquires at the earliest.

 
 

Contact us

NEXUS NDT SERVICES

No,7/12A,II cross street,Vishalakshi nagar,Ekkattuthangal,Chennai-600032
Tamilnadu, India.

Phone/fax:044-22251167

E-Mail-admin@nexusndt.com

R.KUMARESAN

Contact No: 09498056114

Alternate contact: 09486281716